1. How many volts is the mic bias?
Rear Panel: 8V when BIAS is on.
Front Panel: 5V when BIAS is on.
Front Panel Mic Jack pin 6: 8V always on.
2. Why does the filter selection always end in 5 (2.65, 2.75, 2.85 & etc)?
The filter system is currently handled in 50 Hz steps. Might change in a
future firmware rev.
3. Can the Absolute S Meter function be set to ignore the RF Gain setting?
It always takes the IF AGC control voltage into account. Since that voltage
could be generated by a signal or the RF Gain control, the S Meter assumes it
is a signal and applies it to the calculation.
73,
Lyle KK7P
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
