Confusion still reins about the front panel mic. jack. The manual says pin 6
has 8v. This post says "5v when BIAS is on". So I measured it.
Front Panel Mic. Jack:
Pin 2 (PTT) has 5V no matter if BIAS is on or off.
Pin 6 has 8 V always on.
Steve Ellington
[EMAIL PROTECTED]
----- Original Message -----
From: "lyle johnson" <[EMAIL PROTECTED]>
To: "Joe Word" <[EMAIL PROTECTED]>; <[email protected]>
Sent: Thursday, May 15, 2008 10:55 AM
Subject: Re: [Elecraft] K3 Questions
1. How many volts is the mic bias?
Rear Panel: 8V when BIAS is on.
Front Panel: 5V when BIAS is on.
Front Panel Mic Jack pin 6: 8V always on.
2. Why does the filter selection always end in 5 (2.65, 2.75, 2.85 &
etc)?
The filter system is currently handled in 50 Hz steps. Might change in a
future firmware rev.
3. Can the Absolute S Meter function be set to ignore the RF Gain
setting?
It always takes the IF AGC control voltage into account. Since that
voltage
could be generated by a signal or the RF Gain control, the S Meter assumes
it
is a signal and applies it to the calculation.
73,
Lyle KK7P
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG.
Version: 8.0.100 / Virus Database: 269.23.16/1434 - Release Date: 5/15/2008
7:24 AM
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
