I can understand your frustration, but there may be a simplier
solution. The K2 comes with the parts to make a simple RF probe: 1N34A
diode, .01 uf cap, 47 M ohm resistor and a length of RG-174 coax. You
should be able to order all of the parts from Elecraft, including the
small PC board that is used - part number E100079 (it's also used as a
spacing tool for mounting the front panel switches). The instructions
are on page 9 of Appendix E in the K2 manual that can be downloaded
from
the Elecraft web site.
For that matter, someone who has already built their K2 and used a
'scope instead of the RF probe probably has all the bits lying around
and would send them to Jon if he asked.
--
73 de Brian, WB6RQN
Brian Lloyd - brian HYPHEN wb6rqn AT lloyd DOT com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
