Gary Hvizdak wrote:
Dick,
A curious question … are you using a Heil manufactured adaptor
cable, and if so, which one? Kenwood, Icom, Yeasu/Ten-Tec, other?
Gary KI4GGX
P.S. TTFN?
------------------------------------------------------------------------
*Dick Roth KA1OZ*
/Fri May 16 23:29:35 EDT 2008/
------------------------------------------------------------------------
Hi Folks--
I finally got to reading parts of the Owner's Manual and tried to set up
the rig to monitor my mic audio while in Test Mode. I can't get either
front panel Heil HM-Pro or rear panel Heil Proset 5 to pass audio. I
made sure I wasn't in Split and that the mode (USB) made sense.
Regardless of whether I'm set MAIN:FP or MAIN:rP.
Any ideas where to start first?
ttfn &
--
73,
Dick ka1oz
Middleborough, MA
K3/100(Kit) SN 000859
Ah Ha!!! I found my problem! The mics were set for low impedance
rather than high. I made the adjustment and I'm now modulating.
However, I find that my Heil phones really can't hear a monitor signal.
I can begin to hear myself if I crank up the compress to maximum
smoke...likewise the mic gain.
But bottom line is that I'm out of the woods and have a working radio.
Thanks for offering help to all.
Have a good night...
ttfn &
--
73,
Dick ka1oz
Middleborough, MA
K3/100(Kit) SN 000859
Titan-DX (to come)
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
