Won't the washer under the knob scratch the front panel?
On Thu, May 22, 2008 at 7:30 PM, Vic K2VCO <[EMAIL PROTECTED]> wrote: > Nick Henwood wrote: >> >> My K2 has developed a very small amount of play on the pot (R5) used >> for RIT/XIT. Replacement is obviously a possibility (but not sure it >> is worth trying to do doing that yet). It hasn't had rough treatment >> - anyone else had this experience and are there any "quick fix" > > Well...it's not a complete fix, but if you obtain a nylon washer with an > inside diameter that will pass the shaft and an outside diameter that is > about the size of the knob or slightly smaller, you can put it over the > shaft and it will help hold it straight. I found appropriate washers at my > local hardware store. > -- > 73, > Vic, K2VCO > Fresno CA > http://www.qsl.net/k2vco > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
