On Sun Jun 8 2008 at 2313 EDT Bob Cunnings (NW8L) wrote ... I've observed the NB icon blinking sometimes, only when the hardware blanker is being used. What does that mean? I can't find any mention of this in the manual or in the more recent firmware release notes on the website.
-- Hi Bob, Per the rev. C1-4, K3 Owner's manual errata dated May 5, 2008 ... ========================================================================= Page 24, bottom of left column, add: The NB icon will flash on/off if the I.F. blanker setting is too high for the present signal conditions. If this happens, use a lower setting. ========================================================================= 73, Gary KI4GGX _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
