Ah, the errata! I suppose it's the "blanking level" component of the NB setting which is "too high", which makes sense. Thanks,
Bob NW8L On Sun, Jun 8, 2008 at 9:56 PM, Gary Hvizdak <[EMAIL PROTECTED]> wrote: > On Sun Jun 8 2008 at 2313 EDT Bob Cunnings (NW8L) wrote ... > > I've observed the NB icon blinking sometimes, only when the hardware > blanker is being used. What does that mean? I can't find any mention > of this in the manual or in the more recent firmware release notes on > the website. > > -- > > Hi Bob, > > Per the rev. C1-4, K3 Owner's manual errata dated May 5, 2008 ... > > ========================================================================= > Page 24, bottom of left column, add: > > The NB icon will flash on/off if the I.F. blanker setting is too high for > the present signal conditions. If this happens, use a lower setting. > ========================================================================= > > 73, > Gary KI4GGX > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
