Jerry/N8BM said: Might it be a good idea to allow the storage and then recall of the power level in those memories on a per band basis? Personally I would like to store a power level appropriate for driving my amp on each band. So when I select a particular band via a memory recall I can be absolutely assured that it is at a specific and known level each and every time that I use one of the memories. If my intention is to run the full 100 watts than I will need to crank the PWR control. Better doing that than risk damage to an amp. The current PWR SET>Per Band would remain intact.
..and I tend to agree even if -so far- I have not been using any solid state amps, one of my tube amp:s is a high risk amp while the other one can easily take 100 W+. I would appreciate this function if it is possible, Wayne et al. Len SM7BIC _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
