Lennart Michaëlsson wrote: > > Jerry/N8BM said: > > Might it be a good idea to allow the storage and then recall of the > power level in those memories on a per band basis? Personally I would > like to store a power level appropriate for driving my amp on each band. > So when I select a particular band via a memory recall I can be > absolutely assured that it is at a specific and known level each and > every time that I use one of the memories. If my intention is to run > the full 100 watts than I will need to crank the PWR control. Better > doing that than risk damage to an amp. > Aren't we in danger of going too far down the line of absolving people from having to think for themselves. However did we manage with radios that just put out the power set on the power control?
Personally if I can remember what power I set it is more likely to be what I last set it to than what was set whenever I stored that frequency in memory. Some times I may want to use QRP, some times I may not. I would find it very annoying to have the power level reset whenever I change band or recall a frequency from memory. ----- Julian, G4ILO K3 s/n: 222 K2 s/n: 392 G4ILO's Shack: www.g4ilo.com Zerobeat Ham Forums: www.zerobeat.net/smf -- View this message in context: http://www.nabble.com/K3%3A-Storing-PWR-level-in-memories-tp17739729p17743107.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
