Franki, Check your connections. Some of the microHAM K3 cables have the Line In/Line Out (PC In/PC Out) plugs mislabeled. The 3.5 mm plug with the 3.5 mm female jack (used for subreceiver audio) should be connected to the K3 "Line Out" jack.
73, ... Joe, W4TV > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Franki ON5ZO > Sent: Sunday, June 15, 2008 8:58 AM > To: [email protected] > Subject: [Elecraft] K3: no output on "line out"? > > > I am trying to get set up for RTTY with an MK2R+ and > N1MMLogger / MMTTY. It seems the line out is dead: I don't > get a waterfall on the screen. When I > plug the cable from the other radio in the K3's slot on the > MK2R+, I get a > signal. I tested the cable between rig and interface which > seems OK. So my conclusion is: nothing comes out of the LINE > OUT. I looked through the > manual but only found the LIN OUT level parameter which I > cranked up to the > max but that doesn't fix it. > > Any ideas? Am I forgetting something? > - Franki ON5ZO > > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
