> OK K3 "connoisseurs", I've got some more information on my > RTTY / line out problem. > > - K3 + line out = OK. > - microHAM hardware and software = OK. > - I tune to an RTTY transmission and have the K3 decode. The > tuning aid tells me I'm right on. I'm not using Dual PB and > listen 300Hz wide on a 500Hz roofing filter. K3 decodes 100%. > - MMTTY does NOT show a trace and plays dead. Hence me > believing the line output was dead or the input of the MK2R+ > was broken. > > BUT when I drive the filter wider, say from 800Hz up MMTTY > starts showing a signal. And when I listen 4kHz wide, I see > the spectrum. > HOWEVER what MMTTY shows me is 'skewed', as if MMTTY listens > off frequency while the K3 is dead on. I played with Dual PB > but that doesn't help either. > I consulted the manual but I missed the golden clue? > Does anyone use K3 Line Out to drive MMTTY? And does this occur?
Sounds like the MMTTY tone pair does not match the K3 tone pair. 73, Ed - W0YK _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
