OK K3 "connoisseurs", I've got some more information on my RTTY / line out
problem.
- K3 + line out = OK.
- microHAM hardware and software = OK.
- I tune to an RTTY transmission and have the K3 decode. The tuning aid
tells me I'm right on. I'm not using Dual PB and listen 300Hz wide on a
500Hz roofing filter. K3 decodes 100%.
- MMTTY does NOT show a trace and plays dead. Hence me believing the line
output was dead or the input of the MK2R+ was broken.
BUT when I drive the filter wider, say from 800Hz up MMTTY starts showing a
signal. And when I listen 4kHz wide, I see the spectrum.
HOWEVER what MMTTY shows me is 'skewed', as if MMTTY listens off frequency
while the K3 is dead on. I played with Dual PB but that doesn't help either.
I consulted the manual but I missed the golden clue?
Does anyone use K3 Line Out to drive MMTTY? And does this occur?
TNX again de ON5ZO
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
