Is it me (most likely) but I can't download k3fw2r02.zip. I get a message "Internet Explorer can't download k3fw2r02.zip from ftp.elecraft.com. Any ideas? Tnx N2TK, Tony
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of wayne burdick Sent: Wednesday, June 25, 2008 12:08 PM To: Elecraft Reflector Subject: [Elecraft] K3 BETA Firmware Release -- MCU Revision 2.10 K3 beta-test firmware revision 2.10 is now available. Full details appear below and in the release notes. The use of beta-test firmware is encouraged, but optional. Please send any problem reports to [EMAIL PROTECTED] For instructions on how to obtain and load beta firmware, please see: http://www.elecraft.com/K3/k3_software.htm 73, Wayne N6KR * * * MCU 2.10 / DSP 1.81, 6-22-08 * SYNTHESIZER: Tuning and band-change improvements (prevents ERR PL1, etc.). * NARROW FILTERS IMPROVED: Gain balanced for "FIR" filters (CW and data modes). * NOISE BLANKER can now be used with AGC turned off. * DENOISER (NR): Gain balance improved in SSB and AM modes. * EXT ALC voltages adjusted to match resistors called out in EXT ALC mod document (on the K3 mods page). * TX/RX switching time improvement in DATA-S mode ("SYNC Data", for AMTOR, etc.). PC Control Command Changes (for application software developers): * "PC" (PWR READ) IN K22 MODE now supplies correct value for QRO (KPA3) on/off. * "FA/FB" BAND CHANGE now saves mode for old band before switching to new band. This prevents problems with per-mode bandwidth, etc., following band changes. * "MD" COMMAND FIXED: On 6 m, CW norm/reverse were being reported backwards. On all bands, DATA A and PSK-D were reversed for both get and set (AFSK A and FSK-D were correct). NOTES: When an "MD" command is used to switch between data normal and reverse, it applies to both DATA A and PSK-D (if either of these was in effect), or AFSK A and FSK-D (if either of these was in effect). NOTE: An extension to the "MD" command is in the works to directly get/set K3 data modes. Meanwhile, you can use "SWH43;" to emulate pressing the DATA MD switch, then "DB" to retrieve the data mode text string from VFO B, and "UPB;" / "DNB;" to change the mode. --- http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
