It sounds like you may have a spurious oscillation problem inside the box. A spur can drain a high level of power, be off frequency, destroy finals, etc. The power on one band and none on the other sounds like you may have a component misplaced or wrong value - including the tuning of the coil. Another possibility is a bad solder joint so a critical capacitor value is not being seen. I suggest doing a real thorough visual on both sides of the board and maybe a touch up on all the solder joints on those bands. Al WA6VNN In a message dated 6/27/2008 12:27:19 A.M. Pacific Daylight Time, [EMAIL PROTECTED] writes: I lied about lying about the power, after realigning my filters my 12 and 10m power is normal. The signal is still horrible, however.
-- 73 de n1ywb _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com **************Gas prices getting you down? Search AOL Autos for fuel-efficient used cars. (http://autos.aol.com/used?ncid=aolaut00050000000007) _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
