Personally I really liked the 1.8K filter in my rig during FD. The bands were packed and they'd allow you to squeeze into the tightest of places and take a run freq that you know the guy above and below you is being bugged by people calling you back but you can pick them out of the muck like magic. With judicious use of the shift knob you can center around the frequencies needed for intelligibility and you get all the frequencies that you need and ignore those that you don't. But you do need to be a lil ready to use RIT though..
~Brett On Fri, 2008-07-11 at 15:30 -0700, Bill Maddock wrote: > As a contestor and DXer taht has used 1.8 and 2.1 filters - I prefer the 2.1 > - I had a kenwood 1.8 and it was just 2 tinny sounding. I have used cascaded > 2.1 Inrads in my TS-850s and it was good enough - I have > a 6 khz the factory 2.7 khz and the 2.1 khz in my K3 - most the time > I run my bandwidth at 2.8 which is just above thw 2.7 and it uses the > 6 khz + dsp the audio sounds much nicer - but that it for uncrowded bands > The 2.1 is tight and with the dsp it is just fine - when I crank down on the > dsp bandwidth control I have to use the shift knob to get the audio to > sound better. I don't really think that you would like a 1.8 the 2.1 is tight > enough! Hope this helps > > 73, > > Bill N4ZI www.n4zi.net/Home.htm > > > --- On Fri, 7/11/08, Mike Miller <[EMAIL PROTECTED]> wrote: > > > From: Mike Miller <[EMAIL PROTECTED]> > > Subject: [Elecraft] 1.8 or 2.1 kc Filter > > To: [email protected] > > Date: Friday, July 11, 2008, 2:51 PM > > Anyone have experience with 1.8 and 2.1 kc filters for the > > K3? > > Trying to decide which one to get.. > > > > I am a DXer exclusively......not a contester... > > work CW rarely.... > > > > > > Does the audio from 1.8 sound too pinched....? > > I just dont want to hear a 59+10 signal that is 3 kc..from > > the frequency I am listening on.... > > > > any thoughts? on what filters to get.. > > > > Mike Miller KA5SMA > > _______________________________________________ > > Elecraft mailing list > > Post to: [email protected] > > You must be a subscriber to post to the list. > > Subscriber Info (Addr. Change, sub, unsub etc.): > > http://mailman.qth.net/mailman/listinfo/elecraft > > > > Help: http://mailman.qth.net/subscribers.htm > > Elecraft web page: http://www.elecraft.com > > > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
