Hi All Just completed my K3 SN:1168 last night. Now doing the calibration I ran into the folling problem. Everything went fine until I did get to the transmitter gain part. on 160 to 30 m it says ERR TXG. I puts out 1.1 to 3 watts on these bands. On the higher bands it's ok. I started all over again, but hte problem does exists. Selected filter for transmit is 2.7 so thats not the problem. I did set the offset correct. -0.86. Can't figure out what is wrong. Any help? please
73 de Dick PA3FQA _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
