Sounds like you've done the right things, but double check
http://www.zerobeat.net/mediawiki/index.php/Firmware_Error_codes#ERR_TXG
just in case and please come back to us with the resolution, when you
have one.
--
Extraordinary claims require extraordinary evidence.
-Carl Sagan, astronomer and author (1934-1996)
On 12 Jul 2008, at 10:38, Dick Grolleman wrote:
Hi All
Just completed my K3 SN:1168 last night. Now doing the calibration I
ran into the folling problem. Everything went fine until I did get
to the transmitter gain part.
on 160 to 30 m it says ERR TXG. I puts out 1.1 to 3 watts on these
bands. On the higher bands it's ok.
I started all over again, but hte problem does exists. Selected
filter for transmit is 2.7 so thats not the problem. I did set the
offset correct. -0.86. Can't figure out what is wrong.
Any help? please
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
