Ok..., it seems the ANT switch, which is supposed to be switching between CA and CT while in the LCSet mode, is actually switching antennas as it would do in normal operation. I guess this is a bug, unless I'm doing something wrong here...
73, Drew AF2Z On Sat, 19 Jul 2008 08:30:44 -0400, AF2Z wrote: >Also, while dialing in the L and C values, tap ANT to switch between >CA and CT. However, it seems you can't adjust the two caps >independently; whatever value is dialed in for CA is duplicated for >CT, and vice versa. Is this a bug? > >73, >Drew >AF2Z > > >On Sat, 19 Jul 2008 08:16:37 -0400, AF2Z wrote: > >>You can set the KAT3 menu config entry to LCSet. Exit the menu then >>tap ATU TUNE. You can set the L and C values individually with the A >>and B VFO controls. But it doesn't seem to make any difference in the >>AM received signal as far as I can tell. I'm using a 100' wire for an >>antenna. >> >>73, >>Drew >>AF2Z >> >> > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
