IHi Mike, I had this problem, but after endless fiddling I managed to sneak the board into place without cutting any pins. It *is* difficult and Elecraft ought to do something about it.
Knut - AB2TC Mike Downs-2 wrote: > > I just finished installing the KXV3 option in my K3. Everything went > smoothly until I got to the step on page 10 where you plug the KXV3 > board into J66. The instructions say the pins will just barely clear > the top of J66. Well, try as I might I couldn't get the pins to clear > the top of J66. So I clipped off the tips of the pins until they > cleared J66 and I could plug the KXV3 board into J66. Anyone else have > this problem? If so, Elecraft may want to add something to this effect > to the installation instructions. > > Mike, ks7d > > <snip> > ----- AB2TC - Knut -- View this message in context: http://n2.nabble.com/K3-KXV3-Installation-tp579465p579553.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
