Is it possible to set VFO A to one band, and VFO B to a second band?
I recall some discussion about this in the past, but do not remember
if it was on a tudo list, or if it will be a limitation.
As an example, place VFO A on the 20m band CW mode, and VFO B at a
location on the 40m band CW mode. I have done this with other rigs,
is there a menu setting I am missing, or a limitation of the rig? I
just did a couple of quick searches through the documentation, but I
did not see a reference to it.
I am using the 2.20 firmware. I see that it is supported with the
sub-receiver.
It is handy during a contest to set VFO B to another band, and bounce
there periodically to check activity / propagation, while CQ'ing.
--
David Wilburn
K4DGW
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
