Do you have power per band set in your configuration? If so you may not have advanced the power on 40m. Simply turn the power knob on 40m and make sure you have it set to your desired value.
The first time I turned that option on, all of the bands defaulted to some very low level (0.5?). It's very handy for setting amp drive levels that vary per band so I don't need to use ALC or worry about it as I change bands. 73, Guy. Jack Regan-2 wrote: > > The rig works well on all the USB bands. Mic is a Kenwood 600 ohm dynamic > mic. Bias is on. Front panel Input. > > > > On 7.180 (for example) PTT puts rig in transmit mode. Red TX led comes on. > Voice or tapping the mic is heard from the K3 internal speaker. > > NOTHING MOVES ON THE RF DISPLAY. On 20 USB the display show the > appropriate > peak power output. > > > > I have looked at the manual but cannot find what I need in the wealth of > options. > > > > Hope you guys can help! > > > > I do have the K3 Utility up and running. I went over the crystal > configuration settings that I have with Scott at Elecraft to confirm my > set > up. > > At the time my USB transmissions were working so when Scott confirmed my > choices I felt good about having deciphered the manual! Scott also > confirmed my mic set up. > > > > Was I ever surprised when I could not transmit on 40 LSB this afternoon! > > > > Thanks in advance, > > > > Jack, AE6GC, KX1 #1403, K3-100 Kit #1433. > > > > > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > > -- View this message in context: http://n2.nabble.com/K3-100--1433-Will-not-transmit-on-40-meters-LSB.-tp687334p719674.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
