Are your power supply and the connections to that supply adequate? Monitor the supply voltage (using the K3 display) to see what happens when you press Tune. I'm guessing that the voltage may be dropping.
Dick, K6KR -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Dick Grolleman Sent: Saturday, August 16, 2008 12:07 PM To: [email protected] Subject: [Elecraft] K3 switches off during high power TX gain calibration Hi All I finaly had my K3 working after five weeks and several replacement boards at 10 watts. I just installed the 100 PA. I'm up to do the high power TX Gain calibration Started on 160, wich was ok. But have trouble on 60, 30 and 6m. When I press tune, the radio switches off it self. Any one else had this problem? Any info is welcome It sure takes a long time this way to get the K3 working received it 5 weeks ago, and still not finished 73 de Dick PA3FQA _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
