Thanks all who replied
problem solved sitched to a bigger power supply and all ok now
many thanks
73 de Dick PA3FQA
----- Original Message -----
From: "Dick Dievendorff" <[EMAIL PROTECTED]>
To: "'Dick Grolleman'" <[EMAIL PROTECTED]>; <[email protected]>
Sent: Saturday, August 16, 2008 9:31 PM
Subject: RE: [Elecraft] K3 switches off during high power TX gain
calibration
Are your power supply and the connections to that supply adequate?
Monitor
the supply voltage (using the K3 display) to see what happens when you
press
Tune. I'm guessing that the voltage may be dropping.
Dick, K6KR
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Dick Grolleman
Sent: Saturday, August 16, 2008 12:07 PM
To: [email protected]
Subject: [Elecraft] K3 switches off during high power TX gain calibration
Hi All
I finaly had my K3 working after five weeks and several replacement boards
at 10 watts. I just installed the 100 PA. I'm up to do the high power TX
Gain calibration
Started on 160, wich was ok. But have trouble on 60, 30 and 6m. When I
press
tune, the radio switches off it self.
Any one else had this problem? Any info is welcome
It sure takes a long time this way to get the K3 working received it 5
weeks
ago, and still not finished
73 de Dick PA3FQA
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
