Hey All,
I could use a little direction here please!
I had a bad mike from the factory, an MH2 ordered with radio. After
working with Scott @ Elecraft, he sent me a replacement. I had nothing
out of the first mike.
Second mike plugged in and radio placed in test mode.
Successfully went thru procedure to set up mike, ALC and CMP levels
using the speaker and not headphones.
Here is where things went sideways. After exiting test mode (TX arrow
not blinking), I was able to make a good QSO to S. Carolina (5/7) BUT my
own TX is coming out of my speaker just like when in test mode! RX audio
is blocked and I hear me. I am sure something I did is causing this. Any
ideas on what is going on? Thanks for any help. 73.
In His service,
Jim Cundiff KB3GFC
K3 # 1264
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
