Normal behavior - monitor setting is independent of TEST mode. If you don't want to monitor your own voice, turn MONITOR down.
Bob NW8L On Sat, Aug 23, 2008 at 11:24 AM, Jim Cundiff <[EMAIL PROTECTED]> wrote: > Hey All, > I could use a little direction here please! > I had a bad mike from the factory, an MH2 ordered with radio. After > working with Scott @ Elecraft, he sent me a replacement. I had nothing out > of the first mike. > > Second mike plugged in and radio placed in test mode. > Successfully went thru procedure to set up mike, ALC and CMP levels using > the speaker and not headphones. > > Here is where things went sideways. After exiting test mode (TX arrow not > blinking), I was able to make a good QSO to S. Carolina (5/7) BUT my own TX > is coming out of my speaker just like when in test mode! RX audio is blocked > and I hear me. I am sure something I did is causing this. Any ideas on what > is going on? Thanks for any help. 73. > > In His service, > Jim Cundiff KB3GFC > K3 # 1264 > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
