I think I've noticed that... Its like the filter opens up a bit and the static comes up but then when the tone is present the filter locks in on it after a bit and the static comes down. I have a feeling that this phenomenon probably helps it to not obliterate weak signal CW sigs but it can be a tad bit annoying with some of the mediocre to loud sigs.
I agree that its a work in progress and if there was ever a guy who will figure out a really slick way to do it its Lyle. Lyle seems to be growing and learning what works better along with the k3. It takes time to get things just right. This coupled with the fact that there is NO way to make everyone happy it can get even tougher. But knowing Lyle he'll strike a good balance and things will improve over time. I'm interested to see/hear what they've been cooking up as of late... ~Brett On Sun, Aug 24, 2008 at 2:41 PM, KM5Q <[EMAIL PROTECTED]> wrote: > Here is a comment I got off-line from a fellow who comments about CW (and I > agree, though my comments applied to SSB): > > quote --> I have been using MCU 2.23, but an older DSP 1.81 to get a decent > sound on CW. The newer DSP takes too long to sync on the CW signal and it > sounds like very soft keying when NR is on and about F=2--3 or so. ... It > brings the signal up out of the static, but destroys the leading edge of the > CW signal. At least that's what I'm seeing here. > > --end of quote > > Some guys like it the way it is, but there's a lot of agreement here that > it's a work in progress, and has even been in digress lately. I know the > developers are listening and I'm it's going to be improved. > > Windy KM5Q > Santa Fe, NM > K3 #764 > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
