Larry,

Version 2.04p firmware does have the sidetone source toggle, so it should work. Are you really tapping the DISPLAY button or are you really pressing it (a HOLD operation).

If all else fails, go to the KIO2 or KPA100 manual (download them from the Electrtft website), and make the Control Board wiring change - it consists of one cut and two added wires (plus a .001 uF capacitor) - not really a lot ot it. The U8-4 sidetone source is more reliable than the U6-25 and several of us who deal with K2 support and repair situations have been lobbying Wayne to eliminate the selection and glue it to the U8-4 source, which would require that owners of K2s below SN 3000 would have to make the wiring change if new firmware is installed.

73,
Don W3FPR

gearjam wrote:
I have upgraded my firmware to the latest revision. (and replaced the I/O 
controller). The sidetone is gone. There is no option to change the source, it 
stays on U8-4 when I tap the display button.
When I put the old IC back, the sidetone returns. My K2 is an older (1644) rig 
and I don't have the 100 watt option or the the KIO2 option installed. Does 
anyone have any ideas?

Thanks, Larry
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
------------------------------------------------------------------------


No virus found in this incoming message.
Checked by AVG - http://www.avg.com Version: 8.0.169 / Virus Database: 270.6.21/1669 - Release Date: 9/12/2008 2:18 PM

_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

Reply via email to