Hello...
I have been using HamRadioDelux ver 4.0 SP4 for the better part of two
years without problems with K2 5957 and KP100 amp. Tonight, the program
couldn't get a frequency reading from the radio and wouldn't connect.
Yes, the radio is on, the PORT is enabled, and the computer RS232 port
is properly configured. I note the following details:
When HRD is trying to connect, and when I'm in PORT, if I press DISPLAY
[sending a frequency reading to the computer, a la the manual] a
"partial" HRD connect screen will come up with the correct frequency,
but in a moment "disconnects." When this happens, all the "partial"
display items on the computer screen from HRD disappear leaving me with
a blank HRD window.
Since this "just" happened after a long time of successful operation,
I'm suspicious. I rolled back WindowsXP to a previous date with no
success. I cycled the radio and computer numerous times with no success.
I disconnected and reconnected the cables. I've been at computers for
almost 30 years, so I don't think I'm overlooking something obvious. I'm
concerned that something in the K2 might have failed. Any help much
appreciated.
...robert
--
Robert G. Strickland PhD ABPH - KE2WY
[EMAIL PROTECTED]
Syracuse, New York, USA
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
