I just assembled K3/100 sn1617 - it also came with KPA3 manual Rev D,
Jan 2008. No errata in my box. Also, no errata on your web site.
Jerry W4UK
At 04:59 PM 9/17/2008, Ron D'Eau Claire wrote:
All of the acorn nuts go on the outside of the fan panel, Gary.
The new acorn nuts were introduced in May, 2008, and their use was
documented in Errata D3, dated May 7,2008 to the KPA3 manual.
The manual was subsequently updated to Rev E to include the errata items.
Rev E was released June 17. The proper installation of the acorn nuts is
covered on Page 14 and shown in Figure 13.
If you got a Rev D manual without the errata, that was a mistake.
Ron AC7AC
-----Original Message-----
It is now alive and well after about 10 hours of build and
calibration/testing time. I did find a few very minor problems with the
assembly instructions that I will share with Elecraft.particularly with the
Fan assembly as the two bottom center acorn nuts interfered with the relay
of the KPAIO3 board and needed to be put on the outside.the instructions are
unclear since the screws and nuts have been changed. All in all the build
went exactly as the manual said. My hat's off to the guys at Elecraft for a
very fine kit. 73 and see you on topband.de gary, kd9sv
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
