> I just assembled K3/100 sn1617 - it also came with KPA3 manual Rev D, > Jan 2008. No errata in my box. Also, no errata on your web site.
I just finished 1450 with KRX3. All of the manuals in the box were one revision old. I printed copies of the most recent manuals on the web and worked from them. Next project, installing the KRX3 in S/N 622. 73, ... Joe, W4TV > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Jerry Flanders > Sent: Wednesday, September 17, 2008 11:39 PM > To: Ron D'Eau Claire; [email protected] > Subject: RE: [Elecraft] K3/100 # 1670 lives > > > I just assembled K3/100 sn1617 - it also came with KPA3 manual Rev D, > Jan 2008. No errata in my box. Also, no errata on your web site. > > Jerry W4UK > > At 04:59 PM 9/17/2008, Ron D'Eau Claire wrote: > >All of the acorn nuts go on the outside of the fan panel, Gary. > > > >The new acorn nuts were introduced in May, 2008, and their use was > >documented in Errata D3, dated May 7,2008 to the KPA3 manual. > > > >The manual was subsequently updated to Rev E to include the errata > >items. Rev E was released June 17. The proper installation > of the acorn > >nuts is covered on Page 14 and shown in Figure 13. > > > >If you got a Rev D manual without the errata, that was a mistake. > > > >Ron AC7AC > > > >-----Original Message----- > > > >It is now alive and well after about 10 hours of build and > >calibration/testing time. I did find a few very minor problems with > >the assembly instructions that I will share with > Elecraft.particularly > >with the Fan assembly as the two bottom center acorn nuts interfered > >with the relay of the KPAIO3 board and needed to be put on the > >outside.the instructions are unclear since the screws and nuts have > >been changed. All in all the build went exactly as the > manual said. > >My hat's off to the guys at Elecraft for a very fine kit. > 73 and see > >you on topband.de gary, kd9sv > > > >_______________________________________________ > >Elecraft mailing list > >Post to: [email protected] > >You must be a subscriber to post to the list. > >Subscriber Info (Addr. Change, sub, unsub etc.): > > http://mailman.qth.net/mailman/listinfo/elecraft > > > >Help: http://mailman.qth.net/subscribers.htm > >Elecraft web page: http://www.elecraft.com > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
