I found last week, with help from a few guys, that my problem was the
controller on the control board that was defective. I received the one
yesterday..... plugged it and turn ON the K2..... now I am able the
enter menu... the K2 in RX.... finally. But when I added my SSB board,
I found that the problem come again..... only when the SSB board is
inserted.
I found that when U1 is there..... pin 6 is short to ground... but
when I remove U1, pin 6 is OK.....
Is it possible that U1 on the SSB board is defective too !?!?!?!?
Thanks,
73
============================
De Jean-François Ménard / VA2SS
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
