Jean-Francios,
I am sorry to tell you that apparently your KSB2 U1 is likely to be damaged.
Is it possible that there was nothing wrong with Control Board U6, but
the entire problem was KSB2 U1? There is a possibility that both were
bad - that happens, but rarely.
73,
Don W3FPR
Jean-François Ménard wrote:
I found last week, with help from a few guys, that my problem was the
controller on the control board that was defective. I received the one
yesterday..... plugged it and turn ON the K2..... now I am able the
enter menu... the K2 in RX.... finally. But when I added my SSB board,
I found that the problem come again..... only when the SSB board is
inserted.
I found that when U1 is there..... pin 6 is short to ground... but
when I remove U1, pin 6 is OK.....
Is it possible that U1 on the SSB board is defective too !?!?!?!?
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
