True, if the KRX3 is installed after the initial build, Joe. I didn't think of that.
Ron -----Original Message----- From: Joe Subich, W4TV [mailto:[EMAIL PROTECTED] Sent: Thursday, September 25, 2008 8:06 PM To: 'Ron D'Eau Claire'; 'Elecraft List' Subject: RE: [Elecraft] KRX3 received Ron, > Interesting about the clock. Did you install the cover over > the clock battery before installing the KRX3 module? Think a minute ... when installing the KRX3, the front panel is removed. Where is the battery? Of course the RTC will be reset - it is disconnected from the battery. 73, ... Joe, W4TV > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Ron > D'Eau Claire > Sent: Thursday, September 25, 2008 7:07 PM > To: 'AD6XY'; [email protected] > Subject: RE: [Elecraft] KRX3 received > > > Good idea Mike. > > Interesting about the clock. Did you install the cover over > the clock battery before installing the KRX3 module? > > If so, did you make sure the cover didn't slide between the > battery contact and the battery itself (Fig 38 pg 33)? > > If you forgot the cover, you may have a short from the + > (outer rim) of the battery and the bottom of the KRX3 module. > In that case you may need a new clock battery. > > Ron > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of AD6XY > Sent: Thursday, September 25, 2008 3:26 PM > To: [email protected] > Subject: RE: [Elecraft] KRX3 received > > > > I did read the preparing for operation section. That is how I > knew to do the calibration of the synth and that I needed to > set up the filters. These took a while because I had to > remember how to do each task, having last done it last March. > Setting antennas comes later and is not a tick-off item. What > would help most is a simple list without any descriptive > text, just to get everyone started. There is currently no > quick-start guide. > > On a related issue, I appear to have lost the date and time > in doing the KRX3 installation. I am sure I set it OK before. > Time was reset to midnight and the date was showing 00.00.00. > > Mike > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
