Hello to the group. K3 01684 'factory built' was delivered last week, and I've only found time to power it up today... It's a K3/10 with the KXV3.
I'm stuck on getting power out on SSB. It took a little while to figure out the CW section, and that now works fine. I've gone over the manual a few times but I must be missing something and I'll bet it's something stupid... But I can't see what it is... Also, looking at the power out options, I have an adjustable 0-12w on HF, but only 0-8w on 6m... Is that right? I could have done with 10w on 6m..... I've yet to connect up my microham interface, I'm hopeful it'll work without problem... Advice about the power issue would be appreciated.. Thanks. 73 Andy http://gd0tep.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
