Deni,
I have used two nuts on each mounting screw. The first nut is very loose,
and the second nut is tight against the other one. The screws can be rotated
by hand. Two nuts are needed to prevent them from falling into the rig.
73 's Steef PA2A
K2 4654
K3 1184
----- Original Message -----
From: "Deni F5VJC" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Wednesday, October 08, 2008 10:59 AM
Subject: [Elecraft] K3 Speaker cabinet resonances
Has anyone found a solution to the cabinet buzz from the K3 internal
speaker?
I've not used the internal speaker until recently on my K3 and now find I
have annoying cabinet buzz around 450Hz and 600Hz, not so good for CW!
I haven't tried any damping as yet and just wondered if anyone has managed
to cure this cabinet resonance.
73,Deni
F5VJC
K3 325
--
View this message in context:
http://n2.nabble.com/K3-Speaker-cabinet-resonances-tp1306081p1306081.html
Sent from the Elecraft mailing list archive at Nabble.com.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
