Randy Hargenrader wrote:
I think I found the problem. Looks like I had a screw head on the Aux
DSP board bumping up against the main board. I have it running now -
first without the hardware and then now with it.... some insulating
patches of tape did the trick after confirming the hardware was
bothering something.
Seems to me that ALL the screws holding the AuxDSP to the standoffs
should be the nylon ones.... sure would have made my life easier!
Hi Randy,
Are you *sure* you fitted the correct hardware (standoffs etc)? I have
built 3 of these now and not had any issues with hardware etc. It is
easy to get the wrong sized standoff or to miss fitting a washer.
73 Ian
--
Ian J Maude, G0VGS
SysOp GB7MBC DX Cluster
Member RSGB, GQRP
K2 #4044 |K3 #455
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
