I'm new at this but occasionally I like to watch the PA temperature for
example. Unless I am wrong, I have to be in Tech Mode to see the PA TEMP
display but I usually end up grabbing the wrong knob and screwing up the tamp
calibration. I would prefer that the calibration adjustments were in a
separate menu from the display options. In this example, the PA temp would be
in 2 menus, tech mode to adjust calibration and either menu or config for
monitoring.
73, Jim
----- Original Message -----
From: David Lankshear
To: [email protected]
Sent: Thursday, October 16, 2008 5:52 PM
Subject: [Elecraft] K3 TECH MD
I've noticed that quite a few enquiries have been resolved by advising the
enquirer to turn TECH MD to ON.
I just wonder if there's any argument to support ever having TECH MD turned
OFF? Might it be just as well to set it permanently ON in a future firmware
release, thus nipping many queries-yet-to-be-raised, in the bud, and maybe
eliminating an unnecessary user option?
If I remember correctly, having read the reflector diligently, this was the
very first firmware option I changed.
73 DaveL G3TJP
K2/100 #5551
K3/100 #1122
------------------------------------------------------------------------------
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
