Jim Miller wrote:
I'm new at this but occasionally I like to watch the PA temperature for
example. Unless I am wrong, I have to be in Tech Mode to see the PA
TEMP display but I usually end up grabbing the wrong knob and screwing
up the tamp calibration. I would prefer that the calibration
adjustments were in a separate menu from the display options. In this
example, the PA temp would be in 2 menus, tech mode to adjust
calibration and either menu or config for monitoring.
If you don't have a sub-RX, you can get the PA temp in the "VFO B" line
of the display by pressing the "DISPLAY" button until it shows something
other than a frequency, and then turning the VFO B knob until you see
"PA nnnC". No tech-mode required for that, and no de-calibration!
~Iain
----- Original Message -----
*From:* David Lankshear <mailto:[EMAIL PROTECTED]>
*To:* [email protected] <mailto:[email protected]>
*Sent:* Thursday, October 16, 2008 5:52 PM
*Subject:* [Elecraft] K3 TECH MD
I've noticed that quite a few enquiries have been resolved by
advising the enquirer to turn TECH MD to ON.
I just wonder if there's any argument to support ever having TECH MD
turned OFF? Might it be just as well to set it permanently ON in a
future firmware release, thus nipping many queries-yet-to-be-raised,
in the bud, and maybe eliminating an unnecessary user option?
If I remember correctly, having read the reflector diligently, this
was the very first firmware option I changed.
73 DaveL G3TJP
K2/100 #5551
K3/100 #1122
------------------------------------------------------------------------
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
------------------------------------------------------------------------
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
