David Pratt wrote:
The KRX3 did not go together well. There
were some protrusions on the KRX3 that did not correspond to the holes
in the metalwork. They caused the metalwork to distort. A manufacturing
or design fault I presume.
Someone mentioned this recently, and Eric's response was that they had
switched PCB suppliers and there was a issue that boards had 'pips' in
the wrong places.
He advised filing these off, as there are enough in the correct
locations to hold the board in place. It's important that the metal
cover and shield box make good contact, so if you have one of these
boards it's a good idea to do this.
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
