I had considered either filing them off or drilling new holes in the
metalwork. However, I'm glad I didn't as my K3/KRX3 was returned to
Elecraft under warranty and I thought that making any changes might have
invalidated the warranty.
73 de David G4DMP
In a recent message, Vic K2VCO <[EMAIL PROTECTED]> writes
David Pratt wrote:
The KRX3 did not go together well. There were some protrusions on
the KRX3 that did not correspond to the holes in the metalwork. They
caused the metalwork to distort. A manufacturing or design fault I
presume.
Someone mentioned this recently, and Eric's response was that they had
switched PCB suppliers and there was a issue that boards had 'pips' in
the wrong places.
He advised filing these off, as there are enough in the correct
locations to hold the board in place. It's important that the metal
cover and shield box make good contact, so if you have one of these
boards it's a good idea to do this.
--
+ - - - - - - - - - - - - - - - - - - - -+
| David M Pratt, Kippax, Leeds, England |
| K1:1117 KX1:0052 K2:1583 XV144 K3:0186 |
+ - - - - - - - - - - - - - - - - - - - -+
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
