Gentlemen,
Pse read carefully. My original thread stated that the FACTORY built K3
was returned so that the FACTORY could install the KRX-3...pips or not,
doesn't matter....does the factory not check out the rig before pushing
them out the door?
I have done more troubleshooting. I still have the HI RFI msg even
though there is no RF present in the shack...even turned off this
computer and nothing was emitting....I cranked up the K3 Utility,
1.1.6.3 and see where the K3 was showing the older MCU 02.24; FPF 00.02
DSP 00.00 and DSP2 NA. While I was able to reload 2.46 the FPF
repeatedly failed...I would get:
FPF firmware failed at load address x.0000
FPF program load failed.
Neither DSP1 or DSP2 would load or verify.
I am stumped as to where to go next.
Ideas pse?
73
Tom
CX7TT
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
