Good afternoon, Tom:
You haven't said, but are you using a "regular" 9 pin serial cable or a
USB-to-serial connection?
If you have the capability, use a "regular" serial cable between the
computer and the K3.
If you have not done so, I suggest that you re-download from the
internet both the K3 Utility program and the firmware elements. After
you download the firmware, check on your computer to see that you have
successfully downloaded all the elements. Check the help files in the K3
Utility program for guidance in troubleshooting.
When ready to upload the new firmware to the K3, get out of Advanced
Mode (View menu) and click on the "Send All Firmware to K3" button.
If you have tried all of these things and still have no luck, then I
suggest you send your problem to [EMAIL PROTECTED]
73,
Ken K3IU
TMorton wrote:
Gentlemen,
Pse read carefully. My original thread stated that the FACTORY built
K3 was returned so that the FACTORY could install the KRX-3...pips or
not, doesn't matter....does the factory not check out the rig before
pushing them out the door?
I have done more troubleshooting. I still have the HI RFI msg even
though there is no RF present in the shack...even turned off this
computer and nothing was emitting....I cranked up the K3 Utility,
1.1.6.3 and see where the K3 was showing the older MCU 02.24; FPF
00.02 DSP 00.00 and DSP2 NA. While I was able to reload 2.46 the FPF
repeatedly failed...I would get:
FPF firmware failed at load address x.0000
FPF program load failed.
Neither DSP1 or DSP2 would load or verify.
I am stumped as to where to go next.
Ideas pse?
73
Tom
CX7TT
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
