I tried this yesterday, but I failed to give sufficient information to
describe my VFO B problems.
K3 1248
Firmware version 2.46
Software N1MM
P4 1.6 GB PC
microHam microkeyer
Working CQWWSSB mostly split on 40.
One problem and two areas of confusion.
1. When I attempt to us BSet, and leave the K3 in that mode for a period
of time while pushing buttons to adjust VFO B, I get a connection to
radio lost message. Not every time but often. I hit retry and it
reconnects immediately. Not sure if a certain button sequence triggers
this, but it is always involving BSet.
2. The manual says I should be able to directly adjust VFO B with BSet.
Does that include direct frequency entry? If so how. I can't make it work.
3. Is it possible to have VFO A tuning at one rate (slow) and VFO B
tuning at another (Fast). This would simplify split tuning on 40m.
Ron W3ZV
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
