> 1. When I attempt to us BSet, and leave the K3 in that mode > for a period of time while pushing buttons to adjust VFO B, > I get a connection to radio lost message. Not every time but > often. I hit retry and it reconnects immediately. Not sure > if a certain button sequence triggers this, but it is always > involving BSet.
When in B Set, the K3 stops responding to the IF; (current operating frequency and mode), FA; (VFO A/Main RX frequency) and FB; (VFO B/KRX3 frequency) polls. If the software has a timeout value (something like 10 seconds in N1MM Logger - six seconds in microHAM Router), software will report a time- out. > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Ron Kenwood > Sent: Saturday, October 25, 2008 6:29 PM > To: Elecraft > Subject: [Elecraft] K3 VFO B problems > > > I tried this yesterday, but I failed to give sufficient > information to > describe my VFO B problems. > > K3 1248 > > Firmware version 2.46 > > Software N1MM > > P4 1.6 GB PC > > microHam microkeyer > > Working CQWWSSB mostly split on 40. > > One problem and two areas of confusion. > > 1. When I attempt to us BSet, and leave the K3 in that mode > for a period > of time while pushing buttons to adjust VFO B, I get a connection to > radio lost message. Not every time but often. I hit retry and it > reconnects immediately. Not sure if a certain button sequence > triggers > this, but it is always involving BSet. > > 2. The manual says I should be able to directly adjust VFO B > with BSet. > Does that include direct frequency entry? If so how. I can't > make it work. > > 3. Is it possible to have VFO A tuning at one rate (slow) and VFO B > tuning at another (Fast). This would simplify split tuning on 40m. > > Ron W3ZV _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
