Steef PA2A wrote:
>
> Hi,
>
> I turned on the K3 today and all CW was gone. Pitch had become 000, where
> I always use 550. Filter width, LO and HI were giving strange results.
>
> In LSB on 40 meters, if I tap memory M1-M4 the passband of the signals
> become smaller but LO/HI, BW and WIDTH do not change. Going to CW and back
> to LSB the receiver seems normal again. Because there is no KDVR3
> installed, I usually got the message: NO DVR or N/A when tapping one of
> the 4 memories. Now unpredictable things happen.
>
> NORM also sets the receiver back to normal. Does anyone have the same
> problem? Reloading the firmware 257 a few times does not correct the
> problem.
>
>
-----
Julian, G4ILO. K2 #392 K3 #222.
http://www.g4ilo.com/ G4ILO's Shack http://www.ham-directory.com/ Ham
Directory http://www.g4ilo.com/kcomm.html KComm for Elecraft K2 and K3
--
View this message in context:
http://n2.nabble.com/memory-problem-tp1386919p1386968.html
Sent from the Elecraft mailing list archive at Nabble.com.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
