Make sure that the KRX3 is fully mated with the SUBIN board connectors. 73 Stewart G3RXQ On Wed, 29 Oct 2008 09:02:50 +0100, Mitch Wolfson DJØQN wrote: > Hi Lyle, > > Thanks for the tip.....I am using 2.46, and it didn't work until you pointed > me in the right direction. > > Since I had the AF Gain set to HI before I installed the KRX3, I now > disabled the KRX3 and changed AF to LO. Then I enabled the KRX3 and changed > AF to HI afterwards, and that solved that problem. > > Now I notice that my KRX3 sensitivity is much lower than the main receiver, > which wasn't the case when I installed it. I will try to figure that problem > out on my own or otherwise contact support. > > Thanks again & 73, > Mitch DJØQN > > ----- Original Message ----- > From: "Lyle Johnson" <[EMAIL PROTECTED]> > To: "Mitch Wolfson DJØQN" <[EMAIL PROTECTED]> > Cc: <elecraft@mailman.qth.net> > Sent: Wednesday, October 29, 2008 1:43 AM > Subject: Re: [Elecraft] K3 - KRX3: AF Gain > > >> Hello Mitch! >> >>> I have the main receiver's AF Gain set to HI, but I can't find a way to >>> enable that function on the KRX3. Am I missing something, or is this a >>> feature request? >>> >> Setting the AF GAIn HI or LO in the CONFIG menu sends the appropriate >> commands to both main and sub receivers if the KRX3 is installed and >> enabled. >> >>> With the main receiver on HI, the difference between the two receivers is >>> too great to be able to hear very well on the KRX3, at least for the hard >>> of hearing. >>> >> The gain imbalance was fixed in firmware release 2.36/1.90. I also >> confirm it is fixed in the latest development release. I have not >> specifically checked this in any interim releases. >> >> Which firmware do you have loaded in yhour K3? >> >> 73, >> >> Lyle KK7P >> > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com
_______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
