Hi Terry: There's an application note that discusses how to get to the nuts holding that panel as part of making a modification to the K3's AF amplifier. It was released a couple of months ago but searching all over the place I cannot find it on the Elecraft Web site. I'll send you a copy directly. Ron AC7AC
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of G4MKP Sent: Sunday, November 09, 2008 2:07 PM To: [email protected] Subject: [Elecraft] Rambling on.... I gave my K3 another RTTY run out for the WAE contest this weekend. Filter set-up exactly the same as CQWW RTTY using the High/low cut-off to about 200Hz made for simple copy of even the weakest US low power stations. The rig once again performed flawlessly and with the newly acquired small beam (TGM) I was able to 'null' out most of the EU wall. In fact, I set the bandwidth to 600Hz and could still work reasonably comfortably - the beam helping here. CQWW CW to look forward to at the end of this month. It will be interesting to compare my score against the FT2000 in 2007. As an aside, I noticed today that the rear panel plate holding the mic in/line in/out sockets is loose. Removing the top cover reveals that getting to the panel is not so straightforward. Is there a sequenced procedure for this minor bit of maintenance? Finally, I ordered the KRX + filters on 10 Sep 08. When can I expect it? Cheers, Terry G4MKP
_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
