MessageI'd like a copy too.
73 & thanks.
Hank K8DD
----- Original Message -----
From: Ron D'Eau Claire
To: 'G4MKP' ; [email protected]
Sent: Sunday, November 09, 2008 5:52 PM
Subject: RE: [Elecraft] Rambling on....
Hi Terry:
There's an application note that discusses how to get to the nuts holding
that panel as part of making a modification to the K3's AF amplifier.
It was released a couple of months ago but searching all over the place I
cannot find it on the Elecraft Web site.
I'll send you a copy directly.
Ron AC7AC
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of G4MKP
Sent: Sunday, November 09, 2008 2:07 PM
To: [email protected]
Subject: [Elecraft] Rambling on....
I gave my K3 another RTTY run out for the WAE contest this weekend. Filter
set-up exactly the same as CQWW RTTY using the High/low cut-off to about 200Hz
made for simple copy of even the weakest US low power stations. The rig once
again performed flawlessly and with the newly acquired small beam (TGM) I was
able to 'null' out most of the EU wall. In fact, I set the bandwidth to 600Hz
and could still work reasonably comfortably - the beam helping here. CQWW CW to
look forward to at the end of this month. It will be interesting to compare my
score against the FT2000 in 2007.
As an aside, I noticed today that the rear panel plate holding the mic
in/line in/out sockets is loose. Removing the top cover reveals that getting to
the panel is not so straightforward. Is there a sequenced procedure for this
minor bit of maintenance?
Finally, I ordered the KRX + filters on 10 Sep 08. When can I expect it?
Cheers,
Terry
G4MKP
------------------------------------------------------------------------------
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
