Evening,
It arrived Friday, opened the box, and nearly died of fright looking
at all the little (and not so little packages). Weather wasn't great
over the weekend, so I've just finished building it.
As my first large "Kit", I thought it the instructions were quite
good. However i'm stuck on one small issue.
I purchased a KTCX03-1 TXCO, and following the instructions for
Calibration procedure no 3. I'm not able to get anywhere. Any
suggestions?
Tomorro, I will update the firmware and try again. I'm just getting
used to the novelty of my 20m dipole tuning from 80m to 6m. That sure
is some ATU.
Regards
de John
EI7IG
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
