Paul Franson-2 wrote:
>
> Just installed my KRX3.
> With the sub receiver set to main ant, it sounds like there is no
> antenna connected to the sub rcvr. If I switch the sub rcvr to ATU and
> connect the antenna to Ant 2 it works fine.
> MCU is 2.58 and DSP1 & 2 are 1.94 - just reloaded them.
> Did I miss something?
>
Check that you removed jumper W4 and that the SUBIN interface board and
connector pins are correctly seated.
73,
Barry N1EU
--
View this message in context:
http://n2.nabble.com/KRX3-No-signal-from-main-antenna-tp1569319p1569489.html
Sent from the Elecraft mailing list archive at Nabble.com.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
